Sic silicon carbide abrasion resistant hydrocyclone Lining Parts RBSic Cyclone Rubber Liner
Hydrocyclone Lining Parts Is The Most Important Part Of The Whole Hydrocyclone. Because The Hydrocyclone Deals With Solid-Liquid Mixture Medium, Its Wear On The Hydrocyclone Is Quite Strong. Therefore, Wear-Resistant Lining Is Needed To Protect The Normal Operation Of The Cyclone. After a Period Of Work, The Lining Needs To Be Replaced. So The Wear-Resistant Linings Produced By Our Company Can Be Better Applied To The Whole Replacement Parts Of The Cyclone.
Cyclone Lining Parts Material:
1, Wear Resistant Rubber2, Polyurethane
3, Silicon Carbide Ceramics
Cyclone Linings Can Be Divided Into:
1, Spigot2, Vortex Finder
3, Cone Lining
4, Cylinder Top Lid
5, Cylinder Lining Feeding
But In General, Silicon Carbide Ceramics And Polyurethane Materials Are Very Hard, So They Are Usually Bonded Directly To The Inner Surface Of Hydrocyclones. Although It Can Be Replaced, It Takes a Lot Of Time. If It's Easy To Replace. We Usually Use Wear-Resistant Rubber Linings, Which Are Easy To Replace. Take Off The Old Rubber Lining And Install The New One.
In Addition, For Some Small-Sized Cyclones, Pure Polyurethane Materials Can Be Used, Without The Need For Steel Skeleton To Provide Pressure.
In Addition, The Hydrocyclone Rubber Lining Parts Is Also Our Company's Main Products. At Present, The Maximum Is FX 838 FX 660. But The Dust Nozzles Of Hydrocyclones Are Usually Made Of Silicon Carbide Ceramics.
Advantages:
- Excellent wear and abrasion protection property.
- Excellent corrosion resistance property
- Excellent heat resistance property
- Excellent impact resistance property
- Excellent for ballistic protection
Applications:
- Mining
- Mineral processing (mineral beneficiation)
- Power generation
- Cement
- Petro-Chemical Refining and Production
- Coal washery
- Steel
- Defense (personal & vehicle armour).
Specifications:
| Item | Unit | Data |
| Temperature of application | ºC | 1380ºC |
| Density | G/cm3 | >3.05 |
| Open porosity | % | <0.1 |
| Bending strength -A | Mpa | 250 (20ºC) |
| Bending strength -B | MPa | 280 (1200ºC ) |
| Modulus of elasticity-A | GPa | 330(20ºC) |
| Modulus of elasticity -B | GPa | 300 ( 1200ºC ) |
| Thermal conductivity | W/m.k | 45 (1200ºC ) |
| Coefficient of thermal expansion | K-1 ×10-6 | 4.5 |
| Rigidity | / | 13 |
| Acid-proof alkaline | / | excellent |
Technical Datas of Steel :
Q235 steel plate for Normal Chemical Analysis (%):
Cr | C | Mn | Si | Other |
24%-30% | 4%-5% | 0.5%-2.5% | 0.5%-1.5% | Less than 2% |
Available Shape and sizes:
Thickness: from 6mm up to 25mm
Regular Shape: SiSiC tiles, SiSiC Pipe tiles, SiSiC Three Links, SiSiC Elbow, SiSiC Cone Cyclone.
Remark: Other sizes and shape are available upon requests.
Packaging:
In carton box, packed in fumigated wooden pallet with net weight 20-24MT/20′FCL.
Packing:
