Nylon 6T is an amorphous nylon resin which exhibits superior transparency, good barrier properties to gases, water, solvents and essentiaoils and high temperature structural properties, which make it suitable for consideration in a number of applications.
| High heat resistance | With a high glass transition temperature, high rigidity is maintained even in the high temperature environment of the engine room. |
| Excellent chemical resistance | Demonstrated the best chemical resistance of polyamides. |
| Small size change caused by water absorption | The size change of water absorption belongs to the lowest category of polyamides, more than 50% lower than PA66. |
Typical Characteristics:
√ Superior transparency
√ Good barrier properties
√ High toughness,high strength
√ High temperature resistance
√ Excellent mouldability
It was widely used in Packacing Indutries
| 1. Blow Moulded Containers |
| 2. Iniection |
| 3. Non Oriented Film |
| 4. Oriented Film |
| 5. Paper Coating |
| 6. Tubes |
| 7. PA6I/6t into Nylon 6 or Nylon 66 |
| 8. Textile |
Injection molding advice and reference(for reference only):
1) Molding equipment
Equipment needs to consider the situation of wear (flame retardant grade is corrosion resistance).
Select a small device with a single injection volume ≥ 10% of the maximum injection capacity.
A standard nozzle will do.
2) Mold:
Also need to consider the selection of wear (flame retardant grade is corrosion resistant) steel.
The exhaust tank is about 10μm.
3) Prepare for drying
After opening, the product that has been exposed to air (has absorbed water) must be redried.
Dehumidifying dryer: The temperature is 100ºC,2~6h
4) Standard molding conditions
Barrel temperature:
NH 320 (315~335)
C3 320 (320~335)
C2 320 (315~335)
C1 310 (300~325)
Lower hopper :70 (50~ 90)
Mold (non-enhanced grade)120 (90~140)
Injection speed: medium speed
Injection pressure: medium pressure
Screw speed :150rpm
