ZC0001 Voltage Sensor is used to measure the potential difference at the ends of the electronic components.
Specification
Range: | -25V~+25V |
Resolution: | 0.01V |
Accuracy: | ±1%F.S |
Typical experiment
Measure electrical potential of power supply and internal resistance
Measure VA characteristic of small bulb, diode and conductor
Ohm's law
Series and parallel connection of resistor
LC oscillation
Series-parallel connection of capacitor
Usage
1. Connect the Voltage Sensor to computer by USB cable.
2. Open the SWR iLab V8.0.
3. Click 'New' to create new experimental template.
Notes
The Voltage Sensor needs calibration before use.
The red conducting wire is connected to the high-voltage terminal and the black conducting wire is connected to the low-voltage terminal so that measured value is positive. Otherwise it will be negative.
When measuring, please do not make the measured voltage exceeds the range of the sensor.
Do not plug in and out USB frequently. Minimum plug interval is 2s.
